ROPP CAP FEEDER INTERFACE CHECKLIST
==================================
Project:
Customer:
Date:
Prepared by:

CLOSURE EVIDENCE
- Closure supplier and reference:
- Cap diameter / height:
- Liner and insert details:
- Pilfer-band / bridge design:
- Decoration or surface-finish restrictions:
- Production closure samples supplied and lot identified: Yes / No

FEEDING REQUIREMENT
- Required replenishment method:
- Bulk-cap storage expectation:
- Preferred orientation method, if already defined:
- Required cap buffer or chute capacity method:
- Cap-present / cap-low / jam sensing required:
- Manual recovery and safe access requirements:

MACHINE INTERFACE
- Cap transfer point:
- Bottle-present / no-bottle-no-cap logic:
- Capper stop signal to feeder:
- Feeder ready / fault signal to capper:
- Line stop, restart and low-cap response to demonstrate:
- Change parts and labelled settings required:

TRIAL AND ACCEPTANCE
- Representative cap lots supplied:
- Scuffing / decoration acceptance method:
- Misorientation and double-cap checks:
- Replenishment test:
- Controlled stop and restart test:
- Jam recovery test:
- Timed run condition and reject definition:
- Deviations / actions / owner / due date:

This blank checklist does not define project-specific safety, performance or acceptance values.